I am tired of fighting to remove the die from my Star sizer... I would like to remove them when cold to save the mess of the warm lube in the body. Anyone out there want to part with the die removal tool?
Thanks Matt
I am tired of fighting to remove the die from my Star sizer... I would like to remove them when cold to save the mess of the warm lube in the body. Anyone out there want to part with the die removal tool?
Thanks Matt
I believe that lathesmith makes them and possibly the perfessor. Worth a try at least.
gmsharps
Lathesmith will hook you up w/ whatever you need.
I rub a light coat of SNOSEAL on the die that going in next. No torn O Rings and goes in w/ firm thumb pressure!
Mount your Star on a plate, drill and tap a hole that is concentric with your die hole. From the bottom side of the mount plate insert a 9/16 or 5/8" bolt in the tapped hole, turn bolt until it touches the lower portion of the die continue turning bolt to remove die. I can use just fingers rotate the bolt when CAR RED is cooled, if really cold I may need to use a small wrench to get the die moving, if lube is warm I use a plastic pen (Sharpie) to remove the die. I find this is quicker than using the factory die remover. Also I like to leave a bullet in the die for quicker setup next time I use the particular die.
I always just turn the heater on and push the die out.
I do this even though I have switched to coatings
Don't like being hammered by the Cast Boolits Staff, then don't be a nail.
The rules are simple to follow.
I do what Hatch does. On with the heater and I use a (approx) 3/4 wood dowel about 3 inches long. Tap it right out (ALWAYS LEAVE A BOOLIT IN ANY DIE) and push in the next one. Nothin to it....
Politicians are a lot like diapers. They should be changed frequently, and for the same reason. Benjamin Franklin
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |