Just ordering a Lee TL309-230-5r.
Does it actually drop at .309 or a couple of thou larger?
TIA
Just ordering a Lee TL309-230-5r.
Does it actually drop at .309 or a couple of thou larger?
TIA
This would be with an alloy of 10-1 lead/tin. If undersize, add linotype. The antimony makes as cast bullets bigger in diameter from the moulds.
From Lee - Mold diameter tolerance
Our bullet mold tolerance is stated diameter, +.003/-.000 inch. http://leeprecision.net/support/inde...eter-tolerance
Last edited by 243winxb; 10-21-2014 at 07:40 PM.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |