After several frustrating casting sessions, I finally got this mold to work the way it should. After much reading and cleaning the mold several times and
then polishing the pins. I finally got a pile of boolits made. I found some 1500 grit sand paper and took the pins and polished the ends to almost mirror
finish and put 2 of the hollow point pins & 2 of the flat pins in the molds and smoked the pins and cavities. This is foreign to me but Al suggested smoking
the mold. I didn't have a whole lot of time but did get a pretty usable pile of boolits. I still need to figure out the pin adjustment thing, some of the solid points have a ring on the end. The hollow points slid off the pins with little effort and that is a good feeling.
Thanks to everyone especially Al @ NOE and Beagle333 for their suggestions to get thing working for me.