Picked up two pristine condition 32 cal molds (quite sure they have never been used or "fondled" for that matter) 1 round ball and 1 Maxiball.
10 bucks each!!!!!!!!!
They both seem to be TC molds, (compared them to two known TC molds that I own) but the Maxiball seems to have a profile I didn't expect.
The forward grease groove is wide, the rear grease groove is narrow (typical) but the rear one has a v-groove profile and isn't flat bottomed, the forward is v'ed on the ends and is flat bottomed.
It also has vent lines on the top half of the blocks, all my TC molds have no vent lines (round ball molds)
Anyone else own a known TC mold in this configuration?
Might just be an early or later design.
Sorry don't have photo's
Let me know.
THANKS
DOWNWIND