I am getting ready to design and make a jig to release tension on (and replace too) the spring on my air gun.
How many inches will the spring need to be released to get it to little or no pressure.
The seal has gone out on my FAVORITE chinwerekebau side cocker and I have to get it apart to figure what kind of seal will be available to repair it.
First I have to build something the release that spring in a controlled manner.
Anyone know of a good "experimenters" air gun site.
A group of airgunners like we are here, not just competitors or shooters?
A hint . . . do not grab the wrong oil container to lube the piston seal . . . it may not be compatible.
At least I hope it is something that simple, but since it started loosing compression within a few shots after oiling, that is my assumption.