460 version of the 358009

[jason f]

http://noebulletmolds.com/smf/index.php/topic,17.0.html

interest thread is here. hollow point version also if interested.

[jason f]

to the top

[Idaho Sharpshooter]

I bought a Lyman mold that is identical about 40 years ago. Should have kept it. Nice to see Swede is offering one. These would probably look good in my 460 G&A ON 70.

[jason f]

any interest in this.

[cainttype]

There's interest... I'm definitely missing one of these.

[94Doug]

Attachment 117383

Something to consider....this is an old Saeco design. I did send a sample to Al a while back.

Doug

[jason f]

There's interest... I'm definitely missing one of these.

check this one out. i asked tom at accurate to draw one up. here it is. be ordering one this evening.

Attachment 117642

[FLYCUTTER]

That's a good look'in bullet 94 Doug. Have you received a response from Al ? If he runs it , I will want one for sure.

[94Doug]

I never really did specifically hear back on this design...it was just one of a few that I sent. I was actually trying to get him fired up about the 311441 that I sent.

Doug

[cainttype]

This mould is on the active buy list on NOE's forum. The RGs are going to have flat, hollow point, and cup point pins according to the email I got from Al.
The pins aren't mentioned in the schematics at this time, so I messaged Al and received the info I'm relating.
Mixed PB/GC cavities are available in 2 & 4 cav designs, if wanted. RG2s are being offered with the option of brass blocks.

[jason f]

bump to top

[jason f]

http://noebulletmolds.com/smf/index....pic,417.0.html

this one is now active

[jason f]

Still need more people

[jason f]

only need one more to get this one made.

[jason f]

one more to go.