ACE Co 6.8 SPC/270 Lite Group Buy

[338RemUltraMag]

Here is our 6.8 SPC boolit, it is going to cast out a 117 gr and with check and lube sit right at 120. this Will fit the magazine with the check just at the bottom of the neck. As far as I know this is the only purpose built boolit for the 6.8 SPC.

This will also make a great boolit for plinking with the 270 Winchester, a 10 gr charge of Unique should make a nice 100 yd load



These molds will be cut from 7075-T6 aluminum, the same aluminum that is used in AR-15 uppers and lowers.

Now for options:

4 cavity $100
6 cavity $125

Shipping will be $6 for USA and $20 for international.

Estimated lead time 8 weeks.

I will offer this as a powder coat option which will run .002 smaller than shown above or standard which is shown above. Please specify when signing up for this mold, since I am not offering a PB version I will not offer this as a 3x3 PC and standard. It will be too complicated to sort the bullets once cast IMO.

Thank you guys for the continued support, I can not say that enough!

Joshua Holtschneider
ACE Co

[338RemUltraMag]

Purchasers:

1. Lights--4 cavity
2. 4 cavity
3. leather2--6 cavity
4. jameslovesjammie-- 6 cavity
5. xes-- 6 cavity
6. Moonie-- 6 cavity PC
7. wcavasos-- 4 cavity
8. chsparkman-- 4 cavity
9. Ed in North Texas-- 6 cavity
10. 1dbbehr-- 6 cavity
11. coltman--- 6 cavity
12. wb2754-- 6 cavity
13. Doc_Stihl -- 6 cavity
14. roysha -- 6 cavity
15.dh2- 4cavity--top punch
16.
17.
18.
19.
20.

[Lights]

I'm in for one STD 4 cavity mold.

[tnelson31]

In for one STD 4 cavity mold.

[338RemUltraMag]

updated

[angus6]

Joshua what are your molds cut out of ?

[338RemUltraMag]

Forgot to add that, fixed it. But it is 7075-T6 aluminum

[Cajun Max]

I will take 4 cavity PC

[338RemUltraMag]

Thank you

[jameslovesjammie]

I will take a 6 cavity standard diameter.

[338RemUltraMag]

Thank you

[nanuk]

tagged for interest

[338RemUltraMag]

Updated

[Moonie]

You guys are going to drive me broke, I'm in for 6 cavity undersize for PC mooniesdl3 at yahoo.com

[wcavasos]

I am in for a 4-cavity STD mould. wcavasos at yahoo.com

[BCB]

What handles? Or did I miss that in the description?...

Thanks...BCB

[wcavasos]

lee 6-cavity. I had the same question and got the answer through PM

[338RemUltraMag]

There was a whole lot more interest in this in the Discussion section.

[chsparkman]

I would like a 4-cav STD mould. Thanks.

[Fishman]

Joshua, I don't have a 6.8 spc, but I would like to get an upper sometime. I wonder if you can offer this with a small meplat instead of a round nose for hunting purposes? I got my blackout mould that way from HM2 and couldn't be happier. Some others might feel the same way.