Here is our 6.8 SPC boolit, it is going to cast out a 117 gr and with check and lube sit right at 120. this Will fit the magazine with the check just at the bottom of the neck. As far as I know this is the only purpose built boolit for the 6.8 SPC.
This will also make a great boolit for plinking with the 270 Winchester, a 10 gr charge of Unique should make a nice 100 yd load
These molds will be cut from 7075-T6 aluminum, the same aluminum that is used in AR-15 uppers and lowers.
Now for options:
4 cavity $100
6 cavity $125
Shipping will be $6 for USA and $20 for international.
Estimated lead time 8 weeks.
I will offer this as a powder coat option which will run .002 smaller than shown above or standard which is shown above. Please specify when signing up for this mold, since I am not offering a PB version I will not offer this as a 3x3 PC and standard. It will be too complicated to sort the bullets once cast IMO.
Thank you guys for the continued support, I can not say that enough!
Joshua Holtschneider
ACE Co