I am sure this has been gone over before. I really like moly lube, but I have had a hard time with it. It seems to harden in the dies and the press. Sometimes requiring a lot of pressure to get it to move. Using my wifes hair dryer helps but it is hard to keep at the right temp to flow. Would a heater work, or would that be too hot. Anyone dealt with this? If so could you give some tips or suggestions. I recently tried to use lymans alox lube but now I have a mix, and accuracy suddenly dropped off. Lymans moly lube has given me great accuracy in several cartridges and I would like to keep using it, but it is a pain.