Sorry all- im sure this has been covered- but im not using the right search terms to find it.
I want to plug the top holes on a lyman size die- (unless there is a good reason to plug the bottom instead?)
basically i'm sizing and lubing lee 230gr tc 45 cal bullets to .452 and am getting lube all over the nose and in the grooves. I'm using an RCBS LAM II-
if i try to shorten it up so only the top holes get exposed i'm afraid i won't fully size the boolit- but i fully admit i only played with a couple before just deciding it was better to ask people who actually know.
any and all advice is appreciated.
mike