Sportflite Help

[Knight Templar]

Hello,
I had a fire and lost the rockchucker ram for my .22 sportflight swage set. Do any of you have a ram or the measurements? I can machine a ram if I have the measurements of the bore sizes, depths, lengths, and such. looking to save some time trying to recreate this from scratch. Would buy the whole setup if I have to but really just need the ram. Thanks in advance.
Lynn

[Swede44mag]

You might contact BT Sniper he may know the measurements you require.

BTW have you been through Chapter, Council & Commandery?

[R.Ph. 380]

Hello,
I had a fire and lost the rockchucker ram for my .22 sportflight swage set. Do any of you have a ram or the measurements? I can machine a ram if I have the measurements of the bore sizes, depths, lengths, and such. looking to save some time trying to recreate this from scratch. Would buy the whole setup if I have to but really just need the ram. Thanks in advance.
Lynn

Call RCBS, they just may send you a new ram.

Bill

[Rat-Man]

If yours looked like this I can tell you the dimensions. The diameter was measured with a micrometer and the rest with a dial caliper. These measurements should be close enough to re-create one that will work.

It is 7.5 inches total length and .999 diameter. The slot is 1.590 x .335 wide starting .955 from the threaded end. The thread is 3/4x16 and stops about at the top of the slot. The bore is 2.565 deep which is a little bit past the bottom of the slot.

I could not measure the toggle end because it is in the press but it should be exactly the same as the stock RCBS ram end.
If you need something else I will try to help if possible.

Rat-Man

[Knight Templar]

Thanks to all who responded. I think i have what i need to manufacture the ram.
You guys are the best!

[xman777]

Well, really now, are you a traveling man?

[Knight Templar]

Yes, I'm a traveling man, from west to east.