Where can I find a round nose insert for my Lee dies, I'm loading 7.5x55 308 cast. The lee seating leaves a deep impression on the bullet.
|
   
   
|
|
Where can I find a round nose insert for my Lee dies, I'm loading 7.5x55 308 cast. The lee seating leaves a deep impression on the bullet.
You can modify your existing one by molding a new interior
of epoxy, like JB weld, with a boolit tip as the form. I have not
done this personally, but it is often reported. I'd put a thin
film of lube over the tip as a release agent.
Bill
If it was easy, anybody could do it.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote