Guys update on the oven situation. Buy a Breville. What a difference. You will only cry once. It has 5 elements and smart heating technolgy. It applies heat where it needs it at the level it needs it. I am getting consistent results with less than a 5 degree temp swing more like 3 through the entire cycle. The elements work like dimmers instead of just on or off. It handles a bigger load than my others too and will still maintain temp. My coating comes out more even, more shiny and the color is repeatable. This is repeatable every time unlike the cheaper ovens I was using. I will retrofit those with a PID at a later date. I am very close to having a 40 worked out that leads worse than anything I have ever owned. It takes a bit more coating in this particular gun but is showing signs of promise. 50-75 rounds and very light streaking yesterday but I have to keep in mind the alloy hadn't fully hardened. Yesterday it was a little over a 12. This am it was 16. If it won't lead in this gun it won't lead in any I bet. I am finding the poly barrels are actually easier on the coating than traditional. Moved to 5-1-7 too. Looks better on the bollits with a hard shoulder like swc and tc.