Anyone using RandyRat's TAC#1 in their Star? What temperature and pressure are you using?
|
   
   
|
|
Anyone using RandyRat's TAC#1 in their Star? What temperature and pressure are you using?
I'm using it in my star, but I don't have thermometer for the heater and I run the turn screw for pressure. When the house in warm during the summers, I don't need the heater. In the winter, I run it for a few minutes, then unplug and plug back in as needed. I would guess the temp it runs best for me is 75-80 degrees. I run the pressure screw at 10-15 turns from when it makes contact with the plunger assembly.
I have been using it in my star with 50 PSI air pressure and the PID set at 105 deg F., which has worked out well for me.
BOB
22LR, 9MM, 45 ACP, 45 LC, 45-70, 6MM BR, 30BR, 222, 204, 22-250, 7-30 WATERS, 12GA, 36 & 44 BP
Thank you. That worked for me too.
Hi Dave. I used some of that Tac#1 lube from ya and it has worked great in the 450 sizer!
Paul
A government that robs from Peter to pay Paul can always depend on the support of Paul.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote