MiHec 30 Heavy Sil brass mold

[smeagols]

I would like a 3 cavity cramer smeagols@roadrunner.com

[alrighty]

I would like a 3 cavity cramer smeagols@roadrunner.com

I guess I better take a four cavity myself.This must be a good design to make a man make his first post.
restorerancientiron(@)gmail.com

[historicfirearms]

Has anyone tried it in 308 semi autos, like a FAL or M1a?

[45 2.1]

Has anyone tried it in 308 semi autos, like a FAL or M1a?

It is basically the same as the 30 Sil ahead of the crimp grooves. It would work, but the base would be about 0.2" below the bottom of the case neck into the powder room of the 308 case.

[Nrut]

I'll take a 3 cav. Cramer HP
76Flatdec (at) hotmail (dot) com

[dlamp]

I'll take a 3 cav. Cramer HP
lampdamon@gmail.com

[quasi]

I will take a 3 cavity Cramer hp

ckulyk at shaw dot ca

[Bjornb]

I'll take a 2cav solid
alaska1957 at gmail dot com

[Humbo]

Please put med down for a 4 cavity solid. Thanks!
bardisattva at gmail dot com

[45 2.1]

Thread updated

[DarthTater]

I'm in for a two cavity solid, please!

headamp at gmail dot com

[jimgun]

I'll take a four cavity solid. thanks jim jgruver2013 at gmail dot com

[FLYCUTTER]

I'm #10 on the list . Please change my e-mail address to .net not .com Sorry!

[Johnny_Cyclone]

"I'll Take" One 2 cavity solid
robert spot simon at cox spot net

Thanks

[Forrest r]

Could you sign me up for a 3 cavity hp mold
forresth at windstream dot net

[rockrat]

4 cav solid please



PapaAlphaVictorPapaATmontrosedotnet Use the capital letter only and go lower case. Other ovious stuff


Is a plain base available?

[45 2.1]

Is a plain base available?

A request to MiHec is in order for that. He could bore out the GC shank.

Thread updated........

[13Echo]

I'll take a three cavity with Cramer pins. Looking to use in a 30-40 Krag.
wliles at bayou dot com

Jerry Liles

[45 2.1]

Thread updated..............

[fatelvis]

Please take me off the list, I lost my job. I'm #12. Thanks-