Anyone got a little strip of flashing they'd sell me/swap me/donate me?

[jonk]

I have Pat Marlin's checkmaker but no local store stocks the .015" Amerimax or any other flashing other than super thin .007" stuff. Before I order online, I'd like a small sample- enough to make perhaps 100 checks.

I'd happily donate/trade/pay it forward/buy whatever for these.

Let me know i fyou have some.

Thanks,
Jon

[Idaho Sharpshooter]

Would lithograph aluminum help? I looked for some out in the shop, and could not locate my stash. Soooooooo, I drove over half a mile to the Newspaper and got about a dozen sheets.
It mikes .008.

If that will work, let me know and I will cut you half a dozen 9x12 inch pieces and mail them to you.

Rich

[.30/30 Guy]

I have some of the Ace Hardware .014" Amerimax stuff. Also have some dead soft .016" x .500" coil stuff that I use for 30 calibers.

PM me if you are interested.

[jonk]

The .008 is a bit thin; however the .014 or .016 would be fine- 30/30 guy, PM inbound.

[Idaho Sharpshooter]

double the .008" and all is well.

Looks like the dirty-thirty guy has you covered.

Rich

[MUSTANG]

I have Pat Marlin's checkmaker but no local store stocks the .015" Amerimax or any other flashing other than super thin .007" stuff. Before I order online, I'd like a small sample- enough to make perhaps 100 checks.

I'd happily donate/trade/pay it forward/buy whatever for these.

Let me know i fyou have some.

Thanks,
Jon

Jon:

Did you get the 0.14 Aluminum Flashing strips you needed? If not drop me a PM with your address ad I'll send you some.

Mustang