Rolling block firing pin?

[beng]

I have looked almost every where to get a firing pin for a Remington rolling block #1 model with the rotary extractor. Have any ideas Thanks beng

[Ed in North Texas]

Have you sent an e-Mail to Ken WomacK? kgwebay@wildblue.net or info@rollingblockparts.com

Is the retainer cutout on top or bottom on these? I got a new firing pin for my NY State model from Wisner's (original was long enough to scare me with the indentation - apparently it was the original FP made for the early inside primed .50-70 cartridges.

Anyway Wisner's makes new ones, both types plus the #5 7mm small tip FP.

Hope that helps.

Ed

[enfield]

I have a lathe so that makes it a whole bunch easier but I think a 1/4 " grade 8 bolt and a file and drill and you to could whip one up. I have made a couple with pieces of bolt and they have fired many a shot.