MiHec 452374 brass four cavity solid or hollow point

[bobo55]

Will a top punch be provided or offerded. Thanks

[alamogunr]

Miha provides a top punch with his molds.

[Lizard333]

What about handles? What type do I need?

[Griz44mag]

The LEE 6 cavity handles will fit the MP molds. You can get them at Midway, grafs, any Lee dealer or order them direct fro Lee (a little more $)

[bigmike13]

I would like a 2 cavity HP with Penta pins
michaelDOTtiltonDOTvtATgmailDOTcom

[Lonegun1894]

I would like the 2 cavity HP. .454" if we get a choice of diameter as I size to .452" for my 1911 but .454" for my .45 Colts. As to which type of HP, which one is more likely to penetrate slightly deeper to make sure it has expansion in addition to being sure of sufficient penetration for hunting use? Thank you.

Lonegun1894 at yahoo dot com

[45 2.1]

if we get a choice of diameter as I size to .452" for my 1911 but .454" for my .45 Colts.

It should cast at 0.454" and sizes easily to 0.452". I put you down for the large round HP pin..... A penta pin is also available.

[Lonegun1894]

Thank you, Sir!

[chprplt]

I'd like to get in on this one. Please put me down for one (1) 4 cavity solid,, .454 and one (1) 4 cavity Cramer hollow point with all pins, .454. Are blank pins available for the Cramer? Thank you for running this one.

[45 2.1]

I'd like to get in on this one. Please put me down for one (1) 4 cavity solid,, .454 and one (1) 4 cavity Cramer hollow point with all pins, .454. Are blank pins available for the Cramer? Thank you for running this one.

I copied your e-mail from another GB.... check it for correctness. No blank pins are offered as they would be very hard to match without a seam on a RN surface (and I won't provide that aggravation to the mould maker). That is why there are two offering, a solid and a HP

[40Super]

After some use with another mold with the penta pins I would like to add an extra set of large hp pins with my mold, thanks.

[bigmike13]

I would like to change mine to a 4 cavity solid if that will not be a problem

[ddeaton]

I will take a 4 cavity solid please. I have been away from here for a while. Need to get my feet wet again!
ddeaton at zoomtown dot com

[Live2Ride]

I would like a four cavity mold with both pin sets. Dan underscore harben at msn dot com. Thank you.

[Iron Mike Golf]

Please put me down for:

1 each 4 cavity Cramer mold
1 set large HP pins
1 set penta HP pins

If possible, I'd like a set of solid pins.

email: sugdenjw at msn daht com

Thanks!

[dogman]

Four cavity solid please

mlmaher at gmail dot com

[45 2.1]

Four cavity solid please.

I need your disguised e-mail address..........................

[DDriller]

I will take a four cavity hp with all pins
fuhr2003 at swbell dot net

[gestes138]

If you're still taking orders, I will take a 4 cavity HP with both sets of pins.
gestes138 at gmail dot com

Thanks

[almostgem]

I'd like one of the Cramer HP 4 cavity with both sets of pins.
Email is almostgem at comcast dot net
Thanks so much
Almostgem
John Gould


Sent from my rooted Kindle Fire running Ice Cream Sandwich.