MiHec 30 Sil Brass three cavity Hollow Point

[RED333]

Digger you got me thinking, I just checked mine, no bent pins.
When I was casting I did find that I have to slow down to allow the lead to cool.
I tap(a few small taps) the handle bolt and open the mold at the same time to keep from breaking the boolits.

[Digger]

ooookay , it's been a bit silent here lately... .... like to hear some more results that any body would like to spare ? , curiosity here ......
I came up with give or take a 169 gr. and Red has about the 171 or so ...
Has any one been able to send some down range yet ?
Haven't had the time myself lately with work and all .....

[RED333]

None down the pipe yet, busy my self.

[Digger]

Couldn't wait any longer ... .... went out to the range just to function test .
Set up a few with 30 gr of IMR 4895 to see what direction to go with in my Garand Tanker ..
Oh yeah !! .... no target set up , just wanted to see how things would work .
At fifty yards was aiming at a milk jug laying on the ground and bounced it twice , the berm was directly behind , with eight in the clip to try out, was darn close with the others.
Full function with clip ejection when empty.
Brass looked good , no flattened primers , no dark blow back around the neck from not enough charge .
Think this little puppy is going to be a lot of fun ....

[hicard]

Anyone know what the BC of this boolit is? After nose sizing this boolit, it works perfectly in my 300 BLK. Just want to know the BC so I can run some ballistic programs for it.

[MiHec]

I still have some of this molds.
PM me if you want one...

[13Echo]

Any still left? I would like a HP version if available.

Jerry Liles

[RED333]

Ya need to get a hold of MiHec, PM and e-mail till ya hear something.

[13Echo]

Squeaky wheel technique? I've sent one PM and left the post on this thread but I need to keep at it? I can do that.

Thanks

Jerry Liles

[MiHec]

I still have some of this molds.
PM me if you want one...

[Oreo]

PM sent MiHec. I want one, please.