MiHec 360640 4 cavity brass Cramer HP

[45 2.1]

Bbttt..................

[practical_man]

I would like a 4 cavity mold with two sets of pins: round hollow point, and a set of pins for casting this as a solid.

What does it weigh as a solid? Will the pins for this and the 359640interchange?

Thanks
John DeJarnette
fort Leavenworth, KS

1practical (dot) man (at) gmail (dot) com

[45 2.1]

[practical_man;1866405] What does it weigh as a solid? This is a guess as i've never cast a solid with it, but under 150 gr. Will the pins for this and the 359640interchange? No

[rintinglen]

Sigh, I can not resist.
I want one with the round pins.
ghoglin at hotmail dot com
I'd have a lot more money if I'd never found this web site.

[JST00]

I'll take one, round pins

[45 2.1]

I'll take one, round pins

Please read the first post. I need a disguised e-mail address (look at the list on post two and you'll figure it out) and the pin choices you want.

[JST00]

Large pins. JST00 at comcast dot net

[Lon246]

One mold with one set large round hollowpoint pins, please.
...lsunderhill...at...q...dot...com...

[dragon813gt]

How long is the nose? I want to make sure it will cycle in my Marlin. I already own a 360-640 but it's a double crimp groove and drops solids at 170. What makes this GB bullet lighter?


Brought to you by TapaTalk.

[45 2.1]

How long is the nose? 0.340" meplat to crimp groove. I trim brass slightly for the Marlin lever actions, but they can have their carrier length extended also (easy to do). I want to make sure it will cycle in my Marlin. I already own a 360-640 but it's a double crimp groove and drops solids at 170. What makes this GB bullet lighter? The boolit is shorter.

[Rattlesnake Charlie]

I'm in for one mold, all pin options:
Pin options: 1) large HP, 2) penta HP, 3)blank pin for flat nose
charles underscore nuss aat yaaahooo daat coom

[dragon813gt]

Please add me for one mold with all pin options. dragon813gt at yahoo dot com.


Brought to you by TapaTalk.

[Thinktwicez71]

please put me down for (1) 4 cavity mold , with large hp , penta , and blank pins. devilsace at hotmail dot com

[happy7]

I'll take one with large round pins info at mattsbullets dot com

[Salmon-boy]

I gotta stop lookin' to see if the other moulds I've committed to are makin' progress...

Put me down for one with large and penta pins - Salmon-boy using comcast for net

[chuck4570]

Could you show the meplat diameter?

[45 2.1]

Could you show the meplat diameter?

Meplat edges are radiused... but if squared off it wouls be around 0.23".

[rintinglen]

Are we there yet? This sure would look nice under my Christmas tree!

[Aaron]

Please add me one four cavity mold with all pins.

Thanks

5090shiloh at gmaildotcom


Aaron

[GaryN]

I would also like to be on the list. gary(underscore)nordgran(at)hotmail(dot)com. One four cavity mould with all the pins. GaryN