For any of you who haven't used the BC hand moulds you're going to love their sprue plates. Of all the moulds I have I favor their plate because of adjustments & set screws.
For any of you who haven't used the BC hand moulds you're going to love their sprue plates. Of all the moulds I have I favor their plate because of adjustments & set screws.
Here is the new thread for this group buy: http://castboolits.gunloads.com/show...84#post1618584
I believe doing it this way will meet the desires of a lot more people. Having posted on this thread will not get you a mold. Please read my first post on the new one and either email or message me to order. The prices are the same but the group buy is no longer limited to only the #34 design.
Last edited by ballisti-cast; 03-05-2012 at 10:24 AM.
I would a 4 cavity FLAT base iron Ballisti-cast mold H&G 34 clone, with cross-venting, no handles.
I have a set of H& G 4 cavity handles. As cast diameter? I'd like as-cast diameter with wheelweights, or wheelweights/50+% lead at no less than .453". I'm not sure if that means a .453" or .454" based on your cavity manipulation abilities. Please advise about diameters. I think .454" as cast, would too large for me, .452" maybe too small before sizing.
I will be sizing to .452" (SAECO lubrisizer).
Diameter of .453" like others above?? Seeking guidance. Thanks.
Email sent today to Ballisti-cast for order commitment.
Last edited by catboat; 04-01-2012 at 11:46 AM. Reason: cross vent option added
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |