Alliant's chart shows a minimum overall length for this load at 1.150. If I leave the bullet seated at that length, the top two lube grooves are exposed. I am not tumble lubing this, the bullets drop at .359 from the mold so I am sizing and lubing with Felix lube and don't like the bullet hanging out that much. The powder range for Bullseye for this is 4.5 to 4.9 grs. I've loaded these with 4.5 seated to an overall length of 1.050 to put all grooves in the case. Do you think pressures will get too high with the bullet seated this deep? Thanks for any help you can give with this. Tom