Need some Lathe work

[Roger Ronas]

Hello fellow members,
I am building a power drive for my Forster case trimmer and need an adapter for it. I would like 3 of these built, they are all the same dimensions.

1 1/4" long piece of 5/8" round stock (prefer steel, alum will work). Threaded inside, one end 5/16-24 x 1/2" deep and other end 5/16"-18 x 1/2" deep.

If you can help pm me please.
Thanks
Roger

[rbertalotto]

I can do this for you. Send me your shipping address and I'll try to have it in the mail in a day or two.

No charge..........someday I'll need something from you!....

Send me an email

rvb100 (at) comcast.net

[Roger Ronas]

E mail sent.
Thank you Roy, people like you keep my spirits up in today's world!

Roger

[rbertalotto]

Roger, the parts are finished and on their way back to you...........

Merry Christmas!

[Roger Ronas]

Thank You Roy,

Many blessings this Holiday season and through the next year.

Roger

[The10mmKid]

Roy, you're . . . . .

[bigfoot]

Goes to show that there are some good guys left in the world!!!!!
Bigfoot

[RayinNH]

You'll find many on this site. Well done Roy. Merry Christmas to you...Ray

[Crawdaddy]

Roger, don't you remember the Godfather? Be careful of owing people favors!

Seriously that was incredibly generous Roy. Nice to know people like you are still around.

[Roger Ronas]

Just received these parts from Roy. What a work of art and fast.
Thank You and Merry Christmas,
Roger

[WickedGoodOutdoors]

Here is a cool idea for someone with a Lathe to make out of Bronze or Stainless.

can someone make these inserts to accept .22LR, .22 mag and .410, 20 Ga, 12 GA?
I would think that with the larger caliburs a screw top or bayonette breach would be needed as the Flare Guuns are only made of Alum and would not handle the pressures

Ill get the measurements of my 25 Cal Flare Gun shells and post them.