I picked up a nice condition used RCBS 32-170-FN rifle mold today. Has
anyone cast with this one? I am hoping to use it for 8x57, not sure what
diameter the thing will put out.
Bill
I picked up a nice condition used RCBS 32-170-FN rifle mold today. Has
anyone cast with this one? I am hoping to use it for 8x57, not sure what
diameter the thing will put out.
Bill
If it was easy, anybody could do it.
mine does at 17 bhn .323+++-.324+ other side .324++-.325
That's my favorite bullet for the .32 Winchester Special. I've not tried it in 8mm.
Glen
Same for me on the 32spl they are made for each other( a match made in heaven). Since mine dropped a little bigger I sized some to .323 loaded in rem. brass 32 grs IMR4895 win. primer= ragged hole at 50yds in my yugo m48. The one cav. is big enough that it might upset to .325, but I picked up a old 323471 lyman in perfect shape for my 8mm so I have another to play with.
I have and it drops at .324 with Lyman #2.I use it in my 32 Specials.
OK, so now I have to buy a Win 94 in .32 Spl - just no choice in the matter, no other
possible solution. . . . . . . .
Sounds like it will be a bit small for 8mm.
Bill
If it was easy, anybody could do it.
I've shot the RCBS 32-170-FN in a 8mm Mauser. For the Mauser, with faster twist, Longer (heavier) boolits are more aptly suited as far as I'm concerned.
It ain't rocket science, it's boolit science.
I have one of those also and it can cast .324. I've shot them in a Comission rifle with a .323 groovebut not enough to really wring out details. It stabilized and showed promise. I was using varget also.
BvT.
Every lawbreaker we allow into our nation, or tolerate in our citizen population leads to the further escalation of law breaking of all kinds and acceptance of evil.
Since almost all aspects of our cultural existence are LIBERAL in most states, this means that the nation is on a trajectory to dissolution by the burden of toleration and acceptance of LAWBREAKING as a norm, a trajectory back to the dark ages of history.
BvT
As a matter of fact, I did.
Bill
If it was easy, anybody could do it.
Then you bought it from me. There seemed to be a few people wanting 32/8mm rifle molds. I brought another the next day but did not sell it.
Well, we had a bit of a discussion about not needing hard alloy for magnum handgun
loads. Nice to meet you - sorry I didn't know you were a Cast Boolit personat the time.
Bill
If it was easy, anybody could do it.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |