has any one replaced the heating elements in the 90 lb. magma pot? mine is going hot-cold hot, lead getting cold then back on. it may be the thermistate. has any one had one go bat. to early to call magma. they are 3 hr. behind me.
has any one replaced the heating elements in the 90 lb. magma pot? mine is going hot-cold hot, lead getting cold then back on. it may be the thermistate. has any one had one go bat. to early to call magma. they are 3 hr. behind me.
i have replaced them it is easy they drive out with a hammer and rod. you can check them with a tester for continuity to see if they work if you can get to the harness what mark# pot is it? it might be bad wiring have wiggled to much you may check that.
The pot on my Master Caster did the same thing, wired a PID temperature control and by passed the installed thermostat, all has worked well with the pot with the PID temperature control installed.
You 2 notice that the original post was posted in 2011?
I guess 686 finally got an answer....
"The only way to deal with an unfree world is to become so absolutely free that your very existence is an act of rebellion."
- Albert Camus -
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |