RotoMetals2RepackboxInline FabricationWideners
ADvertise hereTitan ReloadingMidSouth Shooters SupplyLee Precision

Page 120 of 120 FirstFirst ... 2070110111112113114115116117118119120
Results 2,381 to 2,385 of 2385

Thread: Loading bench pics

  1. #2381
    Boolit Buddy
    Join Date
    May 2006
    Location
    Fort Worth, TX
    Posts
    258

    Loading bench pics



    And holding down an ultra mount.



    Cabinets


  2. #2382
    Boolit Buddy
    Join Date
    Aug 2012
    Location
    Biloxi, MS
    Posts
    215
    Any wobble with the T tracks?

  3. #2383
    Boolit Buddy
    Join Date
    May 2006
    Location
    Fort Worth, TX
    Posts
    258
    Quote Originally Posted by n10sivern View Post
    Any wobble with the T tracks?
    No. I do get a little with the bench not attached to the wall. It's got a false bottom with a lot of weight in it to anchor it down, but not being attached to the wall would be better. This is a temporary set up, so I'll probably not attach it to the wall.

    I do have dedicated holes in the bench top (2x 3/4 plywood) for the Ultramount, but I really can't tell a difference.

  4. #2384
    Boolit Buddy
    Join Date
    Aug 2012
    Location
    Biloxi, MS
    Posts
    215
    I’ve looked at doing both. More time and cost with T tracks. Less versatility with Tee nuts. I’ve watched ultimate reloader videos with the tracks and all his presses have a fair amount of wobble to them. Part of me thinks that they will fail at some point. Part of me thinks a lot of people have done it with no failures. Kinda at a loss on which route to take.

  5. #2385
    Boolit Buddy
    Join Date
    Feb 2006
    Location
    Bassfield MS
    Posts
    179
    I run a 3 burner infrared heater in my shop. It's a 24'x30' open floor plan with 8' ceiling, OSB inside and out, with roofing tin on the outside. Inside was primed and painted to reflect light and seal the OSB, R30 insulation in walls and ceiling, and double pane windows.

    I have zero issues with moister from the propane heater. But then I did not use any type of wrap, other than tar paper near the ground around the outside. Down in the south just the ambient humidity in the air is enough to cause rust if care is not taken.

Page 120 of 120 FirstFirst ... 2070110111112113114115116117118119120

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check