Load DataRotoMetals2WidenersSnyders Jerky
Reloading EverythingLee PrecisionRepackboxInline Fabrication
MidSouth Shooters Supply Titan Reloading
Page 2 of 2 FirstFirst 12
Results 21 to 23 of 23

Thread: Who makes the bullet lube?

  1. 12-27-2006, 10:06 PM #21
    TedH
    TedH is offline
    Boolit Buddy TedH's Avatar
    Join Date
    Feb 2006
    Location
    Missouri
    Posts
    159
    I do have some automotive gasket material. I may try that. I was worried that a gasket might insulate the heater too much.
    Reply With Quote Reply With Quote
  2. 12-28-2006, 12:10 AM #22
    GP100man
    GP100man is offline
    Boolit Master

    GP100man's Avatar
    Join Date
    Jul 2006
    Location
    Southeast, NC (Coastal plains)
    Posts
    2,123
    TedH

    if using plat heater i would cut a piece just big enuff to seal bottom plate.
    Reply With Quote Reply With Quote
  3. 12-28-2006, 07:53 PM #23
    targetshootr
    targetshootr is offline
    Boolit Master
    Join Date
    Apr 2006
    Location
    piedmont NC
    Posts
    1,472
    I have a few sample sticks of White Label to try and wonder if any of them can run through a Star sizer without heat and not cause the booltis to be sticky. That would be ideal cause the heater on mine is tricky to control.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check