Brass ONLY NOE 360180 Wide Flat Nosed Gas Checked Group Buy is Here.

[GLL]

I will take a 1-cavity GC + HP + 3 extra blank pins + drill for temp probe.

Jerry

[castblaster]

What's the weight of the hp

[SciFiJim]

castblaster,
The hollow point version should be approx 165 grains. That is from the designer's drawing in post #14 of this thread.

http://castboolits.gunloads.com/showthread.php?t=53984

[hamour]

Jim, the Boss said it was OK, so put me down for a 4 cavity Brass Mold with GC, all solids no HPTS

Thanks

Hank

Hank (underscore) Austin (at) msn (dot) com

Cost is 111 + 10 + 2.5 = 123.50

Mold + Shipping + insurance = 123.50 USD

[SciFiJim]

Hank,
PM sent.
Jim

[castblaster]

I want it. Rg4 GC
Mhooper at amaonline dot com

[midnight]

I've got 6 group buys in the works now, might as well make it 7. Put me down for a 4 cavity gas check and drill it for the probe. No hollow point.

rwhyte at wi dot rr dot com

Bob

[Rattlesnake Charlie]

I'll take a 2-cavity, hollowpoint, one PB and one GC, plus the extra set of HP pins so I can design my own.
Mold $118
Extra pins $4
S&H $10
Insurance $2.50
Total $134.5
Please PM me for where I send the check.

[ocelott]

Where are we at in the production schedule?

[dragonrider]

OK I give up, I'll take a 4 cavity, GC, NO hollowpoint.

[SciFiJim]

Where are we at in the production schedule?

It is currently scheduled for December. There was some delay in the entire schedule caused by summer vacations in the shop. Hopefully we can get back on a regularly planned schedule now that summer is over.


Thanks,
Jim

[pmer]

Say, I was wondering if this boolit will work in my older Rossi with the slower twist barrel? This boolit looks like quite the deer gitter.

[ocelott]

Say, I was wondering if this boolit will work in my older Rossi with the slower twist barrel? This boolit looks like quite the deer gitter.

As long as you have a 1-24" twist or faster you should be fine

[castblaster]

I'm number 43 on list. Castblaster. Make mine plain base please.

[SciFiJim]

castblaster, I made the change for you.
Jim

[VHoward]

Changed to the other group buy for the 360160 NOE mold.

[dan-g]

I will take one RG4 HP mould (all gas checks)


(please pm address and full name for payment, Im going to send a USPSMO)


Thanks

[longrifle]

when does the this ordering stop and when do i pay?

[SciFiJim]

It is scheduled for production in December. I will probably close it at the end of November. Payment can be made now or anytime before the end of November.

[WHITETAIL]

Jim, put me down for a RG2.
1GC and 1PB.