I use one of these, Brownells screw checker. It has holes tapped in it to double check what fits where, and it has the drill size required.
I use one of these, Brownells screw checker. It has holes tapped in it to double check what fits where, and it has the drill size required.
+1 on the WD-40 without going to a special tapping fluid.
These plug in formulas seem to be pretty close. The first one does come out a little tight for a 6-48 tho. The second one looks better.
http://academic.evergreen.edu/projec...-tap.htm#pitch
Last edited by scb; 03-06-2011 at 12:43 PM.
"Those who would give up essential liberty to purchase a little temporary safety deserve neither liberty nor safety".
Benjamin Franklin
Where an excess of power prevails, property of no sort is duly respected. No man is safe in his opinions, his person, his faculties, or his possessions.
James Madison
99% of the time I use a pre-printed plastic card with tap drill sizes on one side and decimal equivalents of drill sizes on the other. I got them for free from my tool vendor and keep one by each machine in my shop. But sometime you get a non-standard thread diameter/pitch combo that isn't on the chart. The equation I offered is the simplest and easiest to remember version that always gets you close enough to get started.
Thanks for link, I bookmarked it.
Do yourself a favor and get a Brownells catalog,charts,taps,dies,spring stock cerrosafe casenite,Gunsmith Kinks,in short the bible for the gunsmithing trade.
Mathematical formulas have the same effect on me that "Kryptonite" Has on superman. They just throw my brain cells into a state of weakened-confusion.
That little Brownells card that was posted looks like something I could work with.
All this time I've been having to put on my reading glasses then hold my threading-tap up to the light while putting different diameter drill bits in front of it to see which drill bit left just enough threads showing on either edge of my drill bit to be what I was looking for.
Not very scientific but it always seems to work for me; provided I can find the drill bit with just the right diameter.
HollowPoint
If you look at the front of a GOOD number drill bit box the chart is embossed in the metal front.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |