Troy: Please remove me from this GB, I want to get in on the Eagan MX-3 instead, I remain: MT Chambers.........Thanks
Troy: Please remove me from this GB, I want to get in on the Eagan MX-3 instead, I remain: MT Chambers.........Thanks
updated.
I am kind of confused as to what is available. Are brass or RG molds available on this buy?
This country has gone to hell but now there is hope for us.
yes. post 87 for more info.
http://castboolits.gunloads.com/show...t=56593&page=5
troy brass is only available as a separate buy because of the need to have a separate cherry made.
http://castboolits.gunloads.com/showthread.php?t=109536
and it is my understanding that rg's cant be done because of the size of the hp and pins are too small
I think just the DS10-SB 10 cavity mould can't be hollow pointed. That's my impression from the first post with the specifications. I didn't think any of these could be hollow pointed either until I just checked again.
troy please remove me from this buy... going with the eagan mx-3 instead.. thankx
got it.
I would like mine drilled for temp probe.
Thanks
Payment sent to Al via PayPal today.
"The Engine could still smile...it seemed to scare them" -Felix
Landric
Honcho for NOE .38-200 Mk. I British Round Nose Group Buy
Troy,
Please remove me from this buy, went with a 5cav 55gr from NOE leftover from current run. Thanks Dan
we are getting close!
everybody go thru and make sure i got your order right.
Maybe a stupid question, but would a two cavity mold with both cavities hollow pointed be $35 additional per cavity?
Sam
Thanks. Bob. I'm wondering if adding a hollow point–a popular option–incurs a charge that would vary if the entire mold got HP cavities. Having last minute thoughts of a two or three cavity all hollow pointed, but $35 per would put it out of range for me so I figured I'd ask.
Sam
sam i hear you, i can afford only the necessities (in this economy) if i need a hollow point i use my drill press and a very small bit ., since i shoot for target , i rarely have a need for hollow point. i hunt very rarely, usually rats or possum or varmints of some sort .hope the best for you bob
Sam,
The hollow point option is only available in one cavity. This is due in part to clearances. The HP pin that is inserted in the bottom of the blocks has a small handle attached to ease installing/removing the pin. There simply is not enough room available to do 2 cavities. The RG2/4 moulds will not work in this instance because the bullets nose is too small.
Regards,
Tony
Thanks Tony. That's just what I was wondering about and comparing it to. I was thinking a two cavity HP for this mold (Like an RG2) would be real nice.
I'll stick with the straight 3 cavity. That'll be nice, too.
Sam
can I get in on this with a 4cav RN?
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |