Search:

I don't powder coat, but you state you water drop, and powder coat as well. There is no need to water drop, bakeing to cure the PC is undoing the hardness gained by water dropping unless you quench...

Buckshot used to provide that service, think he retired from it.

Back to the top.

I formed all mine from 30-06, just a matter of running them through the Whelen sizing die slowly, I like to then firestorm with a moderate charge of fast powder. You're right, light bullets and light...

My Whelen is a Handi as well, has accounted for several deer.

Nice report, I'm a 35 Whelen fan.

The 311413 is sold, sorry Jerry.

I did cast with the 311413, makes .314 with my ww alloy.

Deleted.

That's where my old mould went. Just kidding, it is a shame. I only have four H&G, pretty nice tools. Hope you can bring it back into service.

I can't, selling these for a friend, I could cast with it later, maybe this afternoon. A nice looking example.

One cavity of each.

NEI combo 458/300/gc, 458/405/gc $50
RCBS 38-148-WC two cavity $40 SPF
Lyman 358311 2 cavity $40 SPF
Ideal 311413 2 cavity $40 SPF
Add $8.30 shipping, USPS MO or personal check please.

LBT 452-200 -SWC 2 cavity $60 including top punch SPF
RCBS 45-200-SWC 2 cavity $45
RCBS 38-150 KT SWC 2 cavity $45 SPF
Lyman 287308 single cavity $45 SPF
Lyman 311332 single cavity $35 SPF...

And don't forget the cylinder throats need to be uniform to each other as well.

Now that makes sense, thanks for posting this.

My reference to base riveting is during the firing sequence, pressure riveting the base before it gets to the neck.

Another possible scenario is the base riveting. Something to consider.

You could try putting an even coat of "mould release agent" in the cavities. A rag wetted with solvent to clean the block faces after it dries. The best use for "release" agent I have found.

Not sure I understand the question either. I have five sizers, and a few duplicate dies as well. You never know.��

I have two moulds, I'm selling for a friend,
Ideal 577 30
Ideal 575 213
Both sets of blocks are very good condition, the 577 30 has a good fitting hb pin,
the 575 213 has a nice hb pin but a...

Sounds like you need to tap the pins in a fuzz to me.

BTTT please.

Great. I have several of his blank top punches, well made.

I'm a member of A&S, Keith is out of pocket there at present.