Search:

Thanks for all the good info guys. Die and machine both operate fine until I tried to size a bullet. Turns out that lead is very sticky on it's own. I was using lubrasizer to size bullets for powder...

The die has been used to size many, many bullets. After it stuck I took it out and cleaned it. Not using lube just sizing then powder coating. Did use a spray lube in die to no avail. I've used this...

Hi all, I'm having problems with my 450. It sizes my 9mm just fine but with my 401's and 452's the cast bullets are getting stuck and are very hard to remove. I've even had to use a hammer to drive...

Well we made it. Finally got internet up and running. Beautiful country with a nice mountain view of a National Forest out my kitchen window. Ended up in Lebanon. Anybody out here?

Thanks everybody for the input. Hoping to make a piece of this country my new home. Should be out there by the 10th. Takes a lomg time to pack up 30+ yrs of living. Who says you can't take it with...

Hi Guys, I will be moving to Virginia around the first of June. Would love to hook up with any fellow shooters and reloaders in the Lebanon area. :grin:

WooHooo

Hi Bill

Sorry if I seemed impatient. Just getting really anxious.

Are any of these 40cal?

Sangamon Co. just south of Spfld.

Looking for a little help here. I'm trying to find an extractor for this rifle. I believe it was made by Remington. It has a few patent numbers(2094577, 2224758, 2223093) and this mod# but no name....

If you don't mind me asking. How much did the work set you back?

That"s the one, thanks. Now to get my bolt up graded and a new stock. I'll be set.
Thanks again, Jim

OK, I remember reading a post in this forum where one of you guys either had done or does work on the SKS triggers. I want to think from Texas maybe. I prepairing to have my SKS updated and would...

Thanks for the replies guys. Would either of you have a recipe to go with this load. I'm considering the MiHec MP mold (160gr HP / 170gr) solids for this cal. I already use his molds for 9mm and 45....

Has anyone had any success in casting and or loading for the 40S&W? Would like to hear from you. Looking for advice and encouragement in persuing this round.

Thanks alot Hickory. You may have just cost me some very hard earned money. Like many here I started casting and loading to save money and shoot more. So, tell me. When exactly does that start? hehe

What mold would you recommend for 7.62x39 SKS and AK-47? Two cavity would be fine. First time caster for rifle. Casting fine looking boolits in MiHec MP molds for 9mm & 45acp at the moment. Any...