Search:

You have full membership, with no restrictions.

Posting pictures can be a little tricky at first.
They have to be in a format the site supports, and there is a size limitation.

Click 'go...

He's been busted and banned.
But keep your guard up. That trick is in fashion with scammer now days.
The Staff can usually catch them with the hour, but sometimes it's still enough time for them...

That's kind of what I was thinking, but my guess was its possessed by an evil spirit and must be punished.

Click the messages you want to get rid of, then near the bottom is a box
that says 'selected messages'.
click that and a list will drop down. On the list is a place for 'delete'.
Click it, and...

I always put my vice on the end/corner.
So far, I've always been happy with it there.

Burn the witch!!!

Cool. Sounds like you're on the mend.

Let us know if all this fancy, new age medical treatments don't work out.
Then we can try a more traditional approach.

We can all do some chants while...

Hang a few around all your windows and doors.

You'll see your inventory better for when it gets low.
Plus it'll keep the vampires out.

Buyers be careful.
Another scammer was just caught & banned within 5 minutes of joining while attacking this thread.

Stay alert folks:
Scammers will often hit the ground running.
That one was caught & banned within 30 minutes of joining, but still had time to get into mischief.

+1 on JB Weld.
Rumor has it that stuff is so good, you could make a boat trailer out of it.

+1 on cleaning & re-oiling the bearing.

Anybody that works on Aluminum engines can probably do it for ya.
Fixing a stripped out spark plug hole with a heli-coil is a pretty common project for them.

I've seen it several times- People have a business rocking along to one degree or another where if they didn't,
they couldn't hold a job at the local gas station.

I'd install & stuff it with something first without epoxy to be sure ya like it.

Of the couple I've seen, they weren't sealed/glued in permanently anyway.
All ya need to do is keep it from moving...

Have ya called Hornady? Their customer service has always been real good to me.

They should still be available. Or, just get a regular nut from the hardware store.

I used to troll people when they tried to relate their pay to a high level executive's.
The way a business is structured, they aren't exactly comparable.
It's more about who is worth more to the...

It might make a pretty good showing by casting with Zinc.

I've learned that if you say a couple 'Hail Marys' and a 'Anna-godda-devida', all sins will be forgiven.:bigsmyl2:

I'll move this thread over to single shot guns.
If ya want it back here,,, let...

We have a big barrel for brass at our range about 2 feet deep in spent cases.
However; there are so many tobacco chewers, I pretend it's not there.

That's how I do it.
Run the pot up until I get some frosting,
then ease the heat off until there is just a hint of it unless I slow down my fill/drop rate.

In years past I'd accumulated several...

Good luck with that project!

I like the spent primer catcher on my Hornady progressive, but other presses I use are beyond frustrating.
I ended up just letting them drop into a 5 gal. bucket, or...

Oppss, I mis-read the model.

It might not be a issue with the spring.
I had a new Japanese made double barrel Browning side by side that was hard to unlock.
I polished the mating surfaces where...

Not sure of the count, but it seems like fewer, and deeper cuts would let ya have a better grip- especially wearing gloves,
and not tend to 'clog up' as quick as a finer pattern would.

They're pretty rare, endangered, and protected down here after we ate almost all of 'em.