Search:

Mine come out .451 to .452. I am running them through a .452 sizer for my Kimber. It makes nice big round holes.

I am also using the 200 gr RNFP Lee's. I backed my charge weight down and seat them at 1.15. I did have one that wouldn't go into battery at a longer length and when I tried to clear it, the boolit...

I asked about wait time when I ordered mine it was 3~4 back around December. I asked if they made these in batches instead of a continuous run and they said yes they are made in batches. That would...

Thanks for the info it sounds like I am on track with the number per stick of lube. Putteral how is the stickiness of the BAC compared to NRA 50/50? If it is pretty much the same I may change my lube...

How many CB is reasonable from 1 stick of lube? I have sized and lubed approximately 2500 CB's from 1 stick so far and was wondering if this sounds right. I am lubing single groove 9 and 45. Also how...

I received my dies, punch and locknuts Thursday. I put them to use this weekend. I have this to say. They are top notch. I have never used a Star until this weekend. It took me 15 minutes to set up...

CASA range is by Little Rock. Great place and friendly people. Wife and I drove up there from North Texas for an USPSA match.

How much for the drilled and tapped lock nuts?

What was your COL for the RNFP's?

To all thanks for the many informative replies. I can understand the need for the shovel handle. The round ball on my Dillon lasted 1 session before I changed it for the roller handle. I am looking...

I was actually going to order the BAC lube. However since I have never used a sizer I thought it best to ask to avoid getting something I didn't need. Thanks for the quick answer.

New question first post.

Well I went ahead and ordered a Star. For the volume of shooting my wife and I are doing it made the best sense. Now do I need hollow sticks of lube or solid sticks?






Well I have taken...

Thanks for the many reply's. The pan was new from Wally World. After the first ones stuck I tapped them out from the back side which dented the pans up bad. The second batch I smoked the pan prior to...

Well after lurking here for a short time I decided to register. I am just beginning to cast my own. I smelted several muffin pan ingots this weekend but had one problem. What is the best way to get...