Search:

Found the link to 450bushmaster form

Has anyone ran cast boolits in their 450 ? I know velma is high. I have a upper that I am planning g on shooting cast in if possible.

Does it come with handles ?

Looking for a 165 gr40cal mould is there a maker?

[I]f I understand you . changing a bbl is easy all you need is a action wrench and a barrel vice. both you can get at midway of make the wrench . If the calibers are different then you need to...

how about just using pyrodx?/ I use it in mine and so much easier to deal with and clean up is so easy ,i do use black but only in my cannon it eats it buy the oz. , so i use other when...

I presume that round is based on the 221 if the shoulder is unchanged then proabally but check with a good smith famlier with that round

the only real problem might be will your ammo go bang everytime ?/ . I been reloading for about 30 yrs and occasionally 1 per year depending I get a misfire. not the best time ot be...

I have a tc contender 4570. for plinking ha ha I iuse 60 grs of pyrdoex juse like the bp load and a 300 grainer for big stuff 45 gr of re7 and a 405. I know a 4570 in a 14 inch bbl is...

thanks i do have a Lyman sizer but I like thing simple and cheap

i use re7 in my tc 14 406 with 47grs is a real thump er but a case full of pyrdoex p and a 300 graineris sissy load. but fun

those groups are not bad under the situation would hurt a bear if needed

di I need a sizing die ofr it ?? I do not hsve one I use lee alox for thoses

I been loading for years . Casting for several but if I am going to gas check for 30 cal and 8 mm what do I need// not sure about the info about them ruger44

I seen the other threads here about cast boolits and the 8mm . If this question has been dealt with before sorry did not know . ok hear goes I have a turk 98 I have shorthen bbl to 20 inches...

I have a 3006acklet rifle I have a 160gr lee mould I can find data for the 3006 but being a bigger case . Any idea on a starting load for the 3006 ackley ?/ i hope if acc is good to use it for...