Search:

Something like that would be nice for a dillon xl750.

i was thinking of doing that. i might do that as well.

what motor are you using? looks like what i have(fc-555) if it's the same how did you drill the hole for the pin? the shaft is very hard. i had to make a adapter, just had to make it bigger. 270165

thats it. thank you.

i have the complete spring assembly. just thought i would give it a try.
269552

Hey TylerR, if you can give it out... what is the hold pattern for the Drop_Hole_Adapter? i was going to remake it so i can use the DAA drop spring.

thanks.

that's a good wife...and i just have 1 box of 1000 primers left!!!

at this point it was 15 hr.

i can try. i am all setup.

i will like that as well.

i am using the same color.268951

Mount for an endoscope... care to share.

sounds good. and .380acp will be good. just need some primers now.

Making any plates for 9mm and 40sw?

what endoscope you using?

267625267626267627267628

Nope, all was good.
i will send picture.

that is what i did with the smaller one. i just made the big one with the FC-555 motor. might just go with a straight coupler with cut off screws on either side.

Well the motor came in. it looks good but now i have to try to drill that hard shaft to put a roll pin in it.
i will send pictures soon.

Well i did order it, when it comes in i will let ya all know how it is.

Tyler, did you get that motor yet? and if you did how did it work?

>40SW be nice.

nice. to bad we dont have something like this for the Bullet Feeder Die.

what case did you use for the speed controller?

that was good, thanks.