Search:

I'll look again but I thought it was closer to Lovex S020.

I just had 5 more 2 cavity Lees delivered to my door for $19.98 each and added them to my dozen or so 2 and 6 cavity Lee molds. Never had any issues other than my urge to cast too fast and frost...

Air rushing over plastic racks provides potential static charge buildup and I would not count on grounding the plastic to provide a 99.9999% safety factor for potential static discharge when...

Have 5,000 Cheddite 209's arriving tomorrow for $45/1,000 delivered to my door...so $4.50 per 100. I was already stocked up to the hilt on #11 caps, musket caps, and centerfire pistol/rifle...

All this time with two '51 Navy sidearms in my toy box and I never knew I was appreciating The Battle of Campeche. Thanks!

I just use a conical mold made for the purpose but as long as you make sure the cylinders are properly sealed after loading, it should be safe. Really depends on cylinder vs mold dimensions. If you...

He meant to use the soft lead slug with no GC on it to serve as an easy starting point when seating the bullet.

Got all of my inventory to last me a long long time from the maintenance crew at the hospital for free when they remodeled the radiology department.

Do these hoodlums count?
291855

Did you notice that this was a 10+ yr old thread? Been there...done that...LOL

Don't pay $37 hazmat gentlemen....they have a $19.95 hazmat code going now. HAZ21X

And she called me crazy when I stocked up on 30,000 various milsurp rounds for pennies per round along with primers, powder and brass for my other chamberings.

No issues here.
GregG', details of you're problems would be helpful.

As many have noted, angle is what it's all about when putting an edge on for certain purposes. The Lansky and Smith's angle systems are inexpensive ($30-$50) and allow a razor fine filet knife or a...

I know a guy that swore by using steel wool wrapped around a bore brush chucked in a drill to de-lead revolver barrels! If you create a brushed or satin finish, you have removed metal which is not...

Don't rely on the scanner to be exact at 600/inch. Scan a small strip of flashing or shim stock that is approximately 0.1" wide and verify with a caliper.

When I first read this post I thought, "Dang! here we go with a double charge waiting to go off!" But, after cooling off a little before replying, I thought in these days and times, our rubber bands...

Bet the mold is way to hot. The tip of that bullet is likely located in the handle slot area of the mold and is less capable to wick away heat. Wait 3 or 4 seconds after the sprues freeze, before...

Did you decide to get the case and bullet feeder?

If you want to make a tasty treat, bone the meat, mix with some pork fat, season and grind into sausages. Put 32 up one day like that. Of course it helped that I worked in a meat market of a small...

At 265 lbs, that thing will chatter at the drop of a feather. If your working brass and alum only, might be OK. But $1400 + shipping will go a long ways toward a used bridgeport or similar. Make...

Mic a known jacketed bullet like a .308", .451" or .452". Sometimes there can be some play in a caliper at different points along the stem.

Is the original CZ barrel on it or has it been rebarreled?

It's the barrel and charge, not the lock, that determines bullet performance. REAL's will work well as long as the bore is not oversized compared to it's bands.

I would be tickled to open red or blue on christmas morning. But if it were coming out of my pocket and I knew all the factual differences posted in this thread, I would go red every time. Again...