Search:

I had both hands done at once met a good wife out of that.Had one done twice along with a cubital tunnel on the right elbow nerve.Eleven years ago.The pain is gone I don't regret that I did it .It...

Thanks you guys :>I had wondered about the cowboy loads cause they seemed higher than standard max.Thank you.Time to load up.

Can anyone recommend a load using bullseye or red dot powder for a LEE 356-125-2R. I wanted to load these up for a 9mm automatic ,and 38 special not +P .These aren't for target shooting but for...

Thanks everyone for the recommendations. It looks like I need to get some bullplate.As for today I have more than a lifetime of permatex high temp antisieze.I tried it today and seems to work fine.

Hi ,all I am working on casting some bullets using the lee 6 cavity and 2 cavity moulds.Can anyone confirm that it is ok to use Wonder Lube 1000 plus to lube the locating pins and sprue bushings?It...

..Greatly appreciated, Buckshot

Thanks guys for the input I guess I will just hold off for a while.If I have to I know I could make something if they became unavailable.Not to be cheap but the little things add up I made a big...

Unfortunately I ran out of money before time.And its not easy around here to drive to any store and get some handles.I was going to make some handles for the 6 cavity mould I have.I already have a...

Thanks for the report this is exactly what I am doing same gun romy g and same bullet.I am assuming you are using a Lee sizer.

If I got this right from the other articles I've read so far.I still need to get a


freechex 2 for making gas checks assuming it is better than the freechex1

and a 311 sizing die kit from lee...

Looks like I will definetely be going gas checks then, I would not want to use a load that wouldn't cycle the gun.Do you size the bullets with the gas checks on?

Hello all A few days ago I ordered a Lee 312-160-2r mold then I found this site and realize I should have gotten the 155 but will try to work with what I have from reading the stickys.I am new to...