Search:

I use a rcbs separator to separate the pins from the brass. I then pour the water off the pins. There is nothing left in the barrel and the pins are still wet to the touch. If you run your hands...

I have been using this straight during the day for over a month. It started slowly with the water getting darker then almost black. If you run your fingers through the pins your hands would be black....

Did you do anything to the barrel to kind of seal it so the black would not rub off. Don't know if my barrel has gone too far to be saved.

gmsharps

They are not cheap. For the Rubber barrel and that rubber gasket on the top is about $80.

gmsharps

I have a Thumblers Tumbler Model B I have had and used for about 40 years. About 6 years ago I started using the wet process with stainless pins for polishing my brass. Using 5 lbs of pins and a...

I may have that I’ll check when I get home

Gmsharps

Glad to see someone pick up the star sizing dies. Now I just need to see what I have to have

Good luck

Gmsharps

Pm sent

Gmsharps

PM Sent

gmsharps

I’ll take #6

Gmsharps

I have a 2die set of c-h 32Win Spl.

Gmsharps

323751

323752

I have a set of nos (new old stock) 2die set by c-h a file trimmer and a neck sizer

Gmsharps

I’ll take this

Gmsharps

This thread is now closed.

Thanks to all,

gmsharps

I think backing off on the spring pressure would alleviate most of the issue.

Gmsharps

Final bump

gmsharps

I'll take this

gmsharps

BTT

gmsharps

BTT

gmsharps

Listed below is a batch of brass I am selling. As far as I know it is all once fired. I have deprimed a few over time but most are still primed with the dead primers. The 45 acp is all large pistol...

This thread is now closed.

Thanks to all.

gmsharps

final bump

gmsharps

BTT

gmsharps

Pm sent on dies

Gmsharps

BTT

gmsharps