Search:

Thanj you for the load data and poats so far. I actually found another canister of trail boss. Anyone have load data for a 250 grain non gas checked bullet? Again, looking for a plinking load.
...

Hi Guys,
Picked up a Charter Arms Bulldog Pug chambered in 44 special day before yesterday. I plan to order a mold or two later this week but would like to go ahead and get started if possible...

I'm moving in about a month and a half to a studio apartment to finish up my undergrad degree(finally). I am looking for a compact setup to keep on loading while I'm there the next two years. I am 11...

You make good point. I guess I should have stated but I have a spare oven that I use in the shop for duracoat etc.

Thanks for letting me know the correct word.

I will give the torch idea a try...

Hi Guys,
I ended up breaking a sprue plate lever on my 6 cavity lee mold. As of now I have replaced the sprue plate lever but the mold is still full of lead and stuck closed. What would be the best...

Thanks for the info so far. I loaded up 200 of these today usinf 4.0 grains of.red dot. They cycled the CM9 and the S&W 909 just fine and seemed lighter recoil than factory loads.

What should the...

Hi guys,
I'm new to reloading 9mm Luger and casting bullets in general. I have cast quite a few .356 dia 124 gr TC bullets from a Lee 6 Cavity mold I bought. The bullets have been lubed with LLA...

Looking forward to shooting some cash 155 grain boolits tomorrow in my 16.5" Handi rifle. Picture shows the 40 rounds I loaded with 10 grains of trailboss this evening. Should be a very pleasant load...

This may be a very dumb question but can anyone tell me the amount of LLA/JPW/MS they are using per batch of lube they make? I know it's 45/45/10 but how does that relate into oz/bottle size.

One...

I want to first tell you guys that, obviously I'm new at casting and somewhat new to reloading so be-warned if my questions seem somewhat "dumb"

I have a Marlin 30-30 Winchester I'd like to cast...

Does this apply to NC students?

Thanks everyone for the comments/encouragement etc. It's a blast and I hope to melt down the rest of the ww's tomorrow. :) should be 400ish lbs.

Thanks for the info guys!

I'll have to pick up some of those muffin pans. Chris, It's my grandpa's turkey fryer. He has a big one and little and this was the big one. I'll have to figure out the...

I spent a few hours today making some ingots and casting a few bullets out of about 100ish lbs of wheel weights. I got 84lbs of ingots out of it. I have about 500lbs more but since this was the first...