Search:

Anyone use this bullet in Marlin 44 mag tubular magazine- load recommendations for hogs and deer-using lyman #2- I realize Lee molds aren't real popular but have had great success using them

Need recommendation for a Lee mold for 44mag marlin rifle for deer and hog hunting

Recommendations for molds and loads? Shooting out of Marlin

Have some cast bullets (lyman #2) lubed with alox + gas ck - plan on loading in 30-06 and 300 win mag at 2200 -2400 fs - should I have any leading problem?

Finally had a chance to shoot some - used reloader #7 35gr velocity 1945fps - seems to be a good load for my rifle - will see how it does on deer in November - my 30-06 cast 170 gr on did 1748fps -...

338 Winchester Mag With Lee C338-220-1R -Casting with Lyman #2 - anyone use it for deer hunting - loads?

thanks for the info - that is the number i was looking for

thanks

what is the oal - crimp at second lube groove?

just curios - i was planning using lyman #2 where the manual calls for a little softer softer alloy - the 3-1 cut should also work -

I have some lead and lyman #2 - how can I make some 1-10 and 1-15 alloy - my lyman book is requiring these alloys for some of my reloading
thanks

What Lee Bullet Mold for Ruger Old Army Black Powder 45 cal would work?

I lost parts of Lee scale when my RV was totaled by a tornado in East Texas - called Lee for parts - they had me send base (only part I could find out in pasture) - they sent me a new one at no...

Will RCBS bullet pullet collects work or do you need to use Hornady collects

Thinking of tumble lubing without gas ck. for 44 mag rifle - up to what speeds should the alox protect from leading

Just got a Marlin 1894 in 44 mag. Thinking about Lee Bullet Mold C429-240-SWC + gas ck. casting with lyman #2 + alox for hunting - any suggestions for loads- anyone use this bullet - will also be...

I have both RCBS and Lyman products - Lyman customer service is horrible - can't say enough good things about RCBS - would not purchase another Lyman product - wish all companies service would be...

Reading up on powder coating - can it be used for all cast rifle and pistol bullets as substitute for lubing - any velocity restrictions - does it solve leading problems?

Am new to using gas checks - have the following questions- 1)when do you put them on when using Lee resizer 2)can they be put on with Lyman 4500 without having the die for particular size bullet -...

Anyone use one who wear trifocals? Any problems

Used a small base RCBS resizing die - seemed to solve the problem - all casing chamber properly - have also ordered the Larry Willis collet die -I normally buy once fired brass - have 7 mag, 300 mag,...

after reading instructions 6 times it finally clicked - thanks

I read the manual and saw the diagram but still can't figure how to put applicator in -
I let the heater heat up lubricant for about 20 minutes then screwed down as instructions call for - the...

Tried it out today and made a mess:
1-had lube in grove, covering bullet, everywhere
2-never did figure out how to put gas check applicator on (need a picture)

I'm reloading 300 win mag using Lee dies - most of the loaded shells feed like butter but about 10% are locking the bolt or won't chamber completely- the brass has been loaded before with no problems...