Search:

I have a BSA large martini action that came with a rf ejector, the lever fingers have been shortened to drop the breech block to align with the rf chamber. NO other changes from the original large...

I made a batch with Min Wax, works fine, first batch so nothing to compare it to.

I read that the coating is a polymer "of some kind" it's for sure some tough stuff!
I have removed it with paint remover followed by wet pin tumbling.
Soaking them in the paint remover for a...

I have a Lee 6 that I drilled and reamed to cast .187 cores. A 6 banger will drop a pile of cores quickly, the process is faster than casting bollits, they don't have to be perfect out of the mold,...

I'll take it!

I have loaded 14.5 of WC820 behind 169gr. jacketed and 174gr cast with no pressure signs or function problems.

Paullacy I have a DC .30 cal., same problem. I took the handles off a defunct Lee Dc mold and added two brass shims to each side to take up the slack. Works fine!
To remove the pinned on handles,...

I'll take lot #43

I have an 80% Arms gen 2 for sale, with router bit and two drill bits, instruction book, some use scratches, no damage. $225.

Look at the 7.62 Nagant case, slight taper.

I have both, the chips seem to clean small cases (5.7X28, .222) better and quicker, clean pockets better, otherwise a tossup.

riverdog I had to dig the 219 out of it's home to check, the .410 barrel has no model number or address line on it. I have a 16ga 220 marked barrel that is identical in the latch/ejector block, the...

I put a .410 mod 220 barrel on a 219, it was out of square top to bottom of the breech, no signs of any mods. I chucked it up and took a light cut or two and when it was square it fit and latched...

In a single
shot application the polymer coating serves no purpose.
In the FN system it was needed to slow extraction till the barrel pressure dropped to a safe level.
The 5.7X28 in a rifle...

I used a paint stripper to remove the plastic from 5.7s, tough stuff! I load and shoot them out of a 17" insert in a H&R Topper. I don't think it needs to be removed to reload the cases, but they...

H&R also made smoothbore 45-70's used by the Navy as line throwing guns. I saw them used many times during underway replenishment operations.

I'll take the 260 new 45 Winchester brass.

I'll take it, PM inbound.

I'll take it, PM inbound.

I'll take that 6.5X55!

I'll take it!

I'll take #6

Pm inbound

PM sent

PM inbound on #9