Search:

I'll take it- rcbs tabletop primer tool new in the box for $70 -pm enroute

Ballistic Tools, Inc sells a primer pocket go/ no go gauge set for lg and sm primers...:Fire:

Thank you for the heads-up.:drinks:

PM sent

btt- lower price, cancel on trades

Spf att

Stainless Wild West Guns Big Loop Lever for Straight Stock Marlin 1895GS-Excellent Condition- $100.00 shipped to lower 48. 1st 'I'll take it' w/PM- Cash or MO..


274677274678274679274680274681...

Altamont N-Frame Conv Grips, Round Butt to Square, Walnut. I can't find a mark on them but they were installed for a very short time.
$65.00 Shipped to lower 48- ...1st 'I'll take it' w/ PM. Cash...

I'll take it, PM enroute (1 box)

Yes, good review ab, it does look slick with the 11 speeds. I have a 1 speed-

273714

What gpidaho above said and if they are still hard to push thru after PC- spray a clean rag with pledge, apply boolits, shake, rattle, roll and they'll go thru like butter. I have a .462 mold I need...

PM Sent

Good info. Is this a 30-30 and did you get the fps? Thanks for posting...

Lee C429-240 SWC- I found this to be most accurate PC'd + W296 + mag primer.

I'll take it- 5. Mitutoya 103-128 1-2" Micrometer - $20 shipped- PM sent.

Smokes Carolina Blue, Yellow Green and a 50/ 50 mix of each gives me great results...

I will take a box, PM inbound.

NZ- Sizing them smaller- thinking they would come out of a round barrel not shaped like a pentagon and most likely get an increase in fps. Don't get me wrong, I'm not looking too improve this load,...

Thx NZ, wondering more if this isn't an indicator of a too tight fit.

What we got here is 3 240gr .429 cast (approx. 12 BH) and coated with Smokes Car. Blue fired from a 5" bbl and recovered after a snow melt. I noticed the pentagonal shape at the based and because...

Great info folks, thank you and I'll check with JES.

I have a 30-30 Marlin 336XLR I want to get re-chambered to 30-30ai. I've spoken with the gunsmiths in my area and only one has my attention but I feel his price is kinda high. So, anyone know of a...

Good stuff folks, thanks for the replies.

I'd like to pillar bed a stock, cutting and fitting my own pillars. Anyone have a source for the aluminum tubing needed and perhaps recommend the size and or hardness? The stock is a Win
Mod 670.

Good stuff fellas, thank you, I'll ck for burrs and go from there...