Search:

I agree also! He's a great guy to deal with!

Check on You Tube for a video on how to open it without a code. Maybe once inside you can fix it.

He was probably trying to get you to say you were using it commercially. That might not be in their warranty.

Mine is the model with the display on the remote box and I had to add a button that plugs into the box. After that, I get all the features.

I thought the bullets went through point first, so nothing touches the point?

Lee's Modern Reloading vol 2 shows 124gr lead
WIN 231 3.3 910
Max 4.0 1035 32900 PSI 1.095

I used a thick piece of leather between the hammer and the firing pin.


Sent from my iPad using Tapatalk

I use Permatex High Temperature AntiSieze once and never worry about it again.

Blackberry!

I have checked my barrel to frame gap and a .002 will not pull out. A .001 will. I have reset my sizing die to make the case as close to flush with the barrel as I can get it. So I do now have my...

These cases were full length resized to fit the Marlin chamber. All my cases are now slightly to short from shoulder to rim. None of the other cases have done this. I'm hoping that these were just...

I have been loading 30-30 for my Marlin for a good while and just recently been loading for my Contender Carbine. I have been without a 30-30 for a while and am shooting up some older reloads in the...

Runs fine in my RCBS, but I keep a dryer sheet in it when empty.

Thanks for that info. I guess I'll start with 3.0 and the 124Lee and work up from there. Or just use the 3.0 if it functions ok.

Try salt water. I've heard it will float tire mulch.

Same here. The RCBS does a great job. Pulled 600 8mm Mausers in a couple of hours.

Same here. 25.0gr of 5744 with a Lee 330gr gives me 1250fps in my Marlin 1895.

According to Speer Ammunition, the GAP is a 23,000 psi cartridge and the standard 45 ACP is 21,000. +P in the ACP is 23,000.

http://www.speer-bullets.com/pdf/45GAP%20Tech%20Brief_150dpi.pdf

I have fired 45GAP in my 1911 chambered in 45ACP. I loaded them light and used a Lee 190gr SWC. They fed and cycled in my Springfield 5" 1911. The extractor held them in place and they worked fine....

Here is what the Chrony manual says about high and low velocities.

G) Low velocity reading. Light conditions not right; try diffusers. You may be shooting during poor light conditions.

H) False...

You don't need the FCD in 38spl. The roll crimp in the seating die does just fine.

A friend made this for my Chrony.
97770

I looked at a pellet stove, but they did not work in a power outage!

Isn't that the brass you make .410's out of? Good score!

No, not Coleman.