Search:

I need a 225 --4c Please Dan Lee

I beliuve that leading the barrle -maybe port... can be part of the learning curve. Mostly on the hot side,
And elbow grease and bore brush are the way not to take them to a gunsmiths.
I hate it...

2k for me, copper
Dan

If someone wants to sell me their bad 6 mold for the $36 PM me

I too realy like your Idea ,,,I shoot light loads often and don't need gaschecks ,removing the bad part and having a plain base...

OHH NOO I now see that you said -- gas check only ---- that wiil work for me
Dan

May I be in for a 2C for now--- and I hope to upgrade when I pay .......
I want to get on the list for now...Is there a chance of a plain base?
This is my first buy so please PM me if I'm doing...

You can have some other low speed cal.. like a 32 -20 or a 32 H&R --- made by a gunsmith... A 9mm 45 acp are others... You may have to change the fireing pin to a smaller non shotgun pin.. ...

No. 4 buckshot in a .223 and less then 2 gr bulleye plus a filler.....I belive a light cast boolet is better,,,
this is a quiet plinking load Dan

Thanks that sounds good for a time frame dan

OK Thanks -- are we talking a few shipped by the end of the year or more likely spring.... and of course I understand that the best plans don't work out every time!
I sounds like I could get...

I like the 7mm idea beter then 6.8mm ,, I hope I can get back to the 30/221 idea.... Will this be Differant then other makers that will shoot cast better?
Maybe shooting on the light load...

would a 30-222 work? Is this about the same as a 7.62x39? Because of all the cheap military brass i would like to stay with the 223 brass to form from. the 35 cal would work for me.dan