Search:

Check with the local ambulance service. In our area they are usually reasonably priced when they take them out of service. Hope this helps.

From Lee website:

https://leeprecision.com/files/instruct/SM%203529.pdf

It works fine and is accurate out to 25 yards as that is the farthest distance at the pistol range. I’m sure it would work well at farther distances or field use if needed. Attached is another...

Highrpm105,

I have that mold. I use wadcutter data for the particular mold due to deep seating required to crimp in the groove. It looks like a wadcutter with a truncated nose. Below are some...

I use both and either work just fine. I favor the RCBS for shorter boolits. The single row of holes seems to help that. I have read of folks putting shot in the holes to block them off if needed but...

Thank you.

A good comparison:

https://youtu.be/ypT8zjSEG9w?si=8lXHw-QVWo_KSZ0V

Reply from Lee:

Hi Joe,

Thanks for reaching out! .504" nose to crimp groove.

Let me know if you have any other questions!

Thank You,

Bazoo,

Thank you. That is what I needed. This would put the gas check below the neck if seated to the crimp groove in a 270 Win. case.

Joe

I submitted a request to Lee for this information and will post the results when received.

mnewcomb59,

Is your NOE 154 FN the gas check or plane base version?

Joe

If this is a new mold Lee will exchange it.

I have been looking at these in the below link. Not cheap but keeps a more traditional look.

https://formriflestocks.co.uk/product/marlin-1895-lever-action-adjustable-stock/

The site shows two...

No drawing but gives overall and crimp groove to nose.

https://support.leeprecision.net/en/knowledgebase/article/cast-bullet-length-dimensions

I’m looking for a dimension from the base or top to the crimp groove of the Lee C277-135-RF. The website only shows the overall length of 0.943. I’m trying to determine if this will seat in a 270...

Some information on the Harvey mold

http://www.lasc.us/Fryxell_Book_Chapter_10_GCkorPB.htm

Looks like a reputable place. Also, Turnbull may be able to answer questions.

https://www.turnbullrestoration.com/

Congratulations.

Congratulations.

I use the mp the 311-410 pb mold in the attached link for said purpose. Not as economical as the Lee molds mentioned but I wanted the hp option. Usually pushed with 3.5 to 4.5 grains of bullseye or...

Congratulations. Looks delicious. Sounds like a great time with family.

Yes. The #311 is the correct top punch for the 358311.

https://www.castpics.net/subsite/TopPunches/Lyman.html

I used a piece of 1/4” x 2” aluminum flat bar. Drilled and countersink holes in the same location as the one that comes with the pot. Works great for all types and sizes and it was free from the...

Congratulations. Very nice. The practice is paying off.

Sounds like you have a good hunting load for that 348

As mentioned Winchester 231 will work fine for the 358311 in 38 special.
This mold has been around along time and is listed in every Lyman book that I have from issue 36 to 48 and of course the...