Search:

Loosen the spru plate so it swings of it's own weight, this allows better venting under the plate getting the air out faster

I use the 427666 and 427098 in a 1866 44-40 lever gun.
It's my understanding that the 427666 is an Ideal copy of the original used when the round was developed in the late 19th century.
I would...

I shoot the 955 in CA in a 66, not much different than a 73, for OAL of 1.58 crimped at the very top of the crimp groove.
No feed problems.
I have 2 4 cav. 955's about 20 years old, you'll like it

Take the barrel off it action, get you some JB bore paste rap a patch around a bore brush apply the bore paste to the patch and from the chamber end
lap the bojedders out of it. Start with a100...

check your PM box

Rock River produces a 1 in 12 twist ,as I have one, shoots the Saeco 225 70 gr rn real well
My barrel is a 24" heavy stainless, don't know if they have a shorter/ lighter version
this is 2 10 round...

I've always used 425 oven temp and 1 hour heat time then ice water quench as quick as possible from oven.
This process takes my 75 %WW 25% lino up to 22 BHN

Check the vent lines in that area, that may be the problem.
Every time I've had one cav not fill out, venting has been the cause

Scuba tank here also, a 90 CU FT 3000 PSI tank will fill that air pistol many many times before needing refiled.

With any revolver single or double action, every time the hammer is cocked it moves the trigger a small amount allowing it
to snap back a small amount causing that clicking sound. To minimize this...

I would except it to be for a 7MM something as 7MM is .284 Ø

For 1903 or 03 A3 springfield

Straight out of the Acc load book: 200 gr lead 11.2 for 1004 fps 11300 cup
.215 lead 10.5 for 945 fps and 11600 cup
These are the only loads listed for cast.
It also warns to NOT reduce loads, use...

My 5 digit 03 gets shot pretty regularly

Take a look at Hawk scopes on pyramid air.
Can't help with a scope. Moderator you will more than likely have to get from an FX dealer

I to saw your post on FB, everyone said more heat except one that said check venting and I agree CHECK the vent lines for blockage
also loosen the spru plate so it just swings of its own weight....

Can you use 378 weathetby mag and neck it down?
If so I have over 100 pieces

It was called "Draw" JC did some pretty fancy gun handling

Forget the flat nose pellets there designed for10 meter(33 FT)not 25 yards.
The JSB's are good pellets but dirty and contain small slivers of lead so wash them in lacquer thinner or similar and re...

Redding bushing dies set up for .002 neck tenson

There's 2 reasons for the voids you have, 1 mold temp and or 2 a venting problem.
Check vent lines adjacent to the cavities, look for burs closing the vents.
pre heat mold on a hot plate while...

Merry Christmas to you and yours

The action could be dry, dry means more friction. Try some lube, Balastol comes to mind!

I've sized 8mm .325 down to .315 by lubing and gas checking in a .325 first then size to .315, boolit grew in length a little but other than that
no distortion

Don't know where your located in OK. but if you can make a trip to the OKC gunclub located 3 miles north of Arcada Ok we have and excellent
trap/skeet range with very good instructors.
SG range is...