All the ways you listed will work the shake dump and bake is the fastest way. Pick whichever one you like.
Type: Posts; User: JASON4X4
Forum: Coatings and Alternatives
All the ways you listed will work the shake dump and bake is the fastest way. Pick whichever one you like.
Forum: Reloading Equipment
I guy I know used to have a pvc chute to a 5 gallon bucket in the floor I think it was 4" pvc
Forum: Coatings and Alternatives
Espc always gives a better coat but shake n bake is great when you have A lot of bullets to do
Forum: Casting Equipment
I had a good size lead volcano in my 100lb smelting pot. Had no idea the lead was wet made a big mess but nobody got hurt
Forum: Coatings and Alternatives
I have never tried it but any videos that I have seen looked like a lot of work which is why I went with powder coating
Forum: Coatings and Alternatives
There is a guy i think his name is elvis ammo on YouTube that preheats his then shakes and bakes
Forum: Reloading Equipment
i orderd one from cabelas today with the shell plates 10% off plus free shipping
Forum: Casting Equipment
I started with muffin pans now have about 15 mini loaf pans from Walmart that I fill 1/4 to 1/2 way stack great and still fit in the pot. I usually run about 400 lbs at a time
Forum: Reloading Equipment
I use wash and wax with lemishine and let air dry on a towel sitting on our dining room table overnight and have never had any spots
Forum: Reloading Equipment
Great job
I have one like this on my list to build just cant seem to find the time
Forum: Lead and Lead Alloys
Good cheap tester I am going to try that
Forum: Casting Equipment
I have never had one apart but I'm sure you could bypass the control just make sure you never run it without the pid because something could melt or start a fire
Forum: Reloading Equipment
I like having a starting point when I set it up never had to adjust it to much
Forum: Lead and Lead Alloys
Good job I would try and sell the solder rolls that stuff can be expensive
Forum: Casting Equipment
I bought my parts separate you can order a longer probe just make sure it is a k type and it should work fine
Forum: Casting Equipment
Great job should hold a couple hundred pounder of lead.
Forum: Casting Equipment
The temp probe is not long enough but everything else will work
Forum: Lead and Lead Alloys
Good job $70 worth of tin for $9 can't beat it.
Forum: Lead and Lead Alloys
Smelt and clean any type of solder and you will be good to go
Forum: Coatings and Alternatives
I soak mine in acetone and let them air dry
Forum: Casting Equipment
I made a pot out of an old 30lb freon jug and used it until I made a large propane pot so I could melt 250LBS at a time
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |