Search:

I have a lee mold for slugs. And when i load them with my wads i use for shot, it causes rhe haul to buldge

Do you just cut it out and place it over the powder? I normally load with birdshot and buckshot. Ive never done slugs. How i would picture it going is; powder, cardboard, slug, filler cardboard,...

hello, im looking for an alternative to bought slug wads, anyone have any suggestions?

Thanks alot guys! Im gonna look into the resources you've mentioned

hello fellas, I recently got some green dot and was told that you can load 9mm and 30-30/ .308 with it and whats more i was told that some of the older reloading books had actual data on it. Does...

I cast for 9mm 30-30 and .308

ive been looking online and came across a few youtube videos of people using powder coat instead of gas checks. They are just putting thr CB in a tub and swirling it to coat it, then putting them in...

i read an article about using plain white rice as a tumble media, has anyone tried this?

Whats the point of the lube? How do you lube them? And whats a good lube?

So what exactly is the point of them? Do they prevent lead fouling in the barrel?

im a budding machinist and i would love blueprints so i can make a few molds. I own a few lee molds however i dont want to make something i already own. Does anyone have a blueprint for a shotgun...

im a budding machinist and i would love blueprints so i can make a few molds. I own a few lee molds however i dont want to make something i already own. Does anyone have a blueprint for a shotgun...

so like many people, im having a hard time finding supplies. Has anyone had good results shooting 308 or 9mm without gas checks at full pressure and powder load?

I had a buddy ask me about casting for his AR15 semi. I told him i wasnt actually sure if you could cast for a magazine fed rifle. So i put the question to you fine folks. Can you cast for an AR15?

It's supposed to be at 1.169 and I'm seated too deeply at 1.086

I used winchester autocomp and I'm around the middle of the load data.

Recently I was reloading some factory(I know cast only) 9mm rounds.i didnt realize my seat depth had managed to move and I was sweating at 1.086 as opposed to the 1.169 my manual says I need to be...

So after reading my lyman's manual I realized that I have load data for the 308 with the 180 grain cast bullet however not the 30-30. I may have mixed up which mold I need. However will they still...

So is it the same mold for my 30-30 then? I have and use a lee LH309 160. Will that work the the 308?

Hello guys, I need a hand again. I'm looking for a good mould for a bolt action .308 that wont break the bank. It can be a double mould or a single. I just need something for hunting and plinking,...

Barrel 0.7140
Slug 0.6825
Claybuster shotgun was 12guage CB8118-12 standard .00460(Remington)
Pink shotgun was ( winchester) .003
Haul remington gunclub 2 3/4 - 1 1/8 -9
12 guage 2.75 -70mm...

So I attempted to do what the picture showed and I couldnt get the slug with the wad down the barrel, the slug went down without a problem however together it was extremely tight, I couldnt even get...

What's a nitro card?

Justin

I've reloaded #8 shot for skeet and for bird however never really done much in the way of slugs. I have a lee 7/8 oz slug mold from lee and I'm shooting a mossberg 500 and I use Remington and...

It's a mossberg 500