Search:

How much did it end up costing ya?

You got any suggestions to prevent wasting any powder when ES'ing. I think its has the best results but I waste so much powder. Any tips or setup tips would be great.

Thanks

But as you can see it doesn't..... look at the second pic.


Update:
I just removed the grips and its on the bottom of the handle frame. Either way its the same number as in pic one.

115509 115510

Ok I get it. Yeah i wanted to know what pre-28 ment and also was stating what I had.
Mine does say highway patrol man, serial number is by the cylinder when its open. And the model number is in the...

OK so mine says highway patrolman but I am still confused by your statement above. Is it pre-28?

What is a Smith & Wesson Highway Patrolman Pre-Model 28. Trying to figure out the pre-model 28 part.

I have a S&W 357 Mag MOD.28-2 with no serial numbers on the butt of the gun, like I have seen...

I would hate to double post. Maybe an admin can move this post over to that section.

If some one does know. I have a S&W 357 Mag MOD.28-2 with no serial numbers on the butt of the gun, like I have seen on some. They might be underneath the grip if removed. However there is a serial...

What is a Smith & Wesson Highway Patrolman Pre-Model 28. Trying to figure out the pre-model 28 part.

Thanks PM sent.

This I know. Which is why i started this post. However I think a hard lube may prevent that from happening. Only way to find out is to try this blue angel and report back. If carnuba was a tad bit...

What kind of problems? Just curious.

Powder coating is not an issue what so ever. All my PC flow fine through it. Just wanted to make a few non PC bullets.

Already experienced that. And I spoke with the Rick and he did say that cast are just fine but you would need to use mica powder. It worked well with mica and prevented sticking during collating and...

I got a Dillion XL 650 with a mr. bullet feeder from double alpha. I need a good hard lube for 45acp and 9mm. The way the mr. bullet feeder works, is it uses stainless steel balls that prevent the...

Thank you !

Incase any one wants to know, Magma said that the COAL for the 9mm mold above is 1.084. I'm waiting for the 45 mold information from them.

Any one know the C.O.A.L. of the 09-115 RN FB mold from Magma Engineering.

Also maybe the COAL for 45-200 RN FB mold as well.

Mold Info:
http://www.magmaengineering.com/PDF/FBMar092011b.pdf

NM storm lake states their barrels are cut broach rifled to shoot jacketed or lead bullets.

Are the Storm Lake's rifled or hexed?

Any glock lovers out there that know of a good barrel for glock 26 in order to shoot cast lead? I see one over at stormlake... just not sure if its made for cast bullets. Doesn't say much about the...

Any one got any tips or mods they have done for the cast capturing once they have left the mold. I need to properly separate the sprew left overs and bullets once dropped from mold.

And any other...

Starbrite Orange Copper is the color. You can buy it from link below.
https://www.powderbuythepound.com/STARBRITE_ORANGE_COPPER/